Home > Exhibition > Content

What do I need to do before using the horizontal injection molding machine?

Sep 10, 2019

Inspection of various components of horizontal injection molding machine

    Inspection of each component includes an electrical control box and various active parts. The part of the electrical control box that needs to be checked is to check whether there is water or oil in the electrical control box. If the appliance is damp, do not turn it on. The maintenance personnel should blow the electrical parts and turn them on again. In addition, it is also necessary to check whether there is lubricating oil in each movable part, because the addition of sufficient lubricating oil plays a relatively large role in the normal operation of the injection molding machine.

 

Heating each section of the barrel

    This operation is to enable the overall temperature of the device to be unified. When the temperature of each section reaches the requirement, it is kept for a further period of time to stabilize the mechanical temperature. The holding time varies according to the requirements of different equipment and plastic materials.

 

    In fact, in addition to the above two parts that need to be operated, it is necessary to check whether the power supply voltage is normal and whether the cooling pipes are long-distance. I hope that everyone can accurately check these points before using the horizontal injection molding machine and do their own preparations.