Home > Exhibition > Content

How to Realize Energy Saving Materials for Large Injection Molding Machine

Jun 26, 2020

The injection molding machine is a device that injects thermosetting plastics into molds of different shapes to finally form plastic products. Large-scale injection molding machines mostly use electromagnetic heaters to achieve energy-saving effects, and in terms of power consumption and energy saving, frequency converters are selected to change the frequency of equipment operating electrical energy, so that the reliability obtained can be better and the reliability achieved can also be more Good performance, so it is necessary to make better choices according to the actual situation, and ultimately the reliability will be greatly improved.

 

    Of course, high-quality large-scale injection molding machines can achieve energy saving materials from heating and power, so it is necessary to make better choices according to the actual situation, and the quality assurance achieved will also have more outstanding performance, so it can be obtained finally. Reliability will also be greatly improved. Choose more to know that the electromagnetic heater can save heating time, directly affect the heating pipe, and the special insulation layer can improve the heating efficiency, and at the same time, the heating efficiency is high, etc., which are the reasons for ensuring more energy saving. Conventional resistance heating coils have low efficiency and large heat loss, so it is very expensive, so the cost of processing plastic products has increased significantly.

 

    We choose the most high-quality large injection molding machine to achieve the best energy saving effect. Above we mentioned the energy saving of the heating part. Now we mainly talk about energy saving in power. If the equipment only needs 30HZ power during operation, and the actual power of the motor may be higher, so it will cause energy waste. Then choose the inverter to adjust it to ensure how large the equipment needs. The power output is as much as possible, so the energy saving effect that can be achieved is definitely the best, so the reliability achieved will be better.