Home > Exhibition > Content

How to realize energy-saving materials for large injection molding machines ?

Jun 28, 2019

Since the injection molding machine is a device that injects thermoplastic into different shapes of molds, the plastic product is finally formed. Large injection molding machines use electromagnetic heaters to achieve energy-saving effects, and in terms of power consumption and energy saving, inverters are selected to change the operating power frequency of the equipment, so that the reliability can be better and the reliability can be improved. Good performance, so it is necessary to make better choices according to the actual situation, and the reliability brought by the end will be greatly improved.


    Of course, the high-quality large-scale injection molding machine energy-saving material is realized from two aspects of heating and power. Therefore, it is necessary to make a better choice according to the actual situation, and the quality assurance achieved will have more outstanding performance, so it can be finally obtained. Reliability will also be greatly improved. The choice is even more ambiguous that the electromagnetic heater can save heating time, directly acting on the heating pipe, and the special insulation layer can improve the heating efficiency, and the heating efficiency is high, etc., which are all reasons for ensuring more energy saving. In the past, the resistance heating coil has low efficiency and large heat loss, so it is very expensive, so the cost of processing plastic products has been greatly improved.


    We choose the best quality large injection molding machine to achieve the best energy saving effect, we mentioned the energy saving of the heating part. Now we mainly talk about energy saving in power. If the equipment only needs 30HZ power in the running process, and the actual power of the motor may be higher, it will cause energy waste. Then choose the inverter to adjust, you can guarantee how big the equipment needs. The power is about how much power is output, so the energy-saving effect that can be achieved in the end is definitely the best, so the reliability achieved will be better.